VERTICAL TRAVEL OF TABLE ------------------ 2"
DIAMETER OF LOCATING HOLE IN TABLE -------- .5002
OVERALL HEIGHT DOWN POSITION
  BASIC UNIT LESS MOTOR BASE -------------- 6-11/16"
  POWER UNIT WITH MOTOR BASE -------------- 7-7/16"
HOLD DOWN SLOTS IN BASE ------------------- 9/16"
MAIN DRIVE MOTOR -------------------------- 1/4 HP

THIS UNIT CAN BE USED WITH A BRIDGEPORT TYPE VERTICAL MILL
TO CUT THREADS FROM A MINIMUM OF #8 I.D. TO MAXIMUM O.D.
OF THE VERTICAL MILL THROAT

TABLE RPM:

  LOW RANGE ------------------------------- 0 TO  7 RPM
  MEDIUM RANGE ---------------------------- 0 TO 12 RPM
  HIGH RANGE ------------------------------ 0 TO 32 RPM
EQUIPPED WITH ---

LEAD SCREWS
CONSOLE